Home

Products

Sample Solutions

FAQ's

Contact Us

Floor Technologies Inc.

Your Floor Experts

PRODUCTS
Gypsum Underlayments

All of the gypsum-based underlayments we install are:

  • designed for use as a non-wearing interior floor underlayment
  • installed on site by our trained and experienced crew
  • formulated to give you a smooth surface, ready for finished floor goods

Gyp-Crete is still the best choice for fire and sound control in multifamily construction. The original, it has stood the test of time since 1972.

Gyp-Crete 2000 3.2K, engineered to reach compressive strengths of 2000-3200 psi, is ideal for use over wood or concrete subfloors in single-family, light commercial, multi-family or renovation construction.

Dura-Cap is formulated to cap rough, pitted, cracked and out of level concrete. In renovation it can be poured directly over old tile and adhesive residue.

Therma-Floor is designed to pour over hot water tubes or electric cable in radiant floor heat systems.  It acts as a thermal mass by encasing the tubes or cables in crack resistant, non-combustible gypsum.

Commercial Topping is poured from a feather-edge to 3" in depth to provide the ultimate strength in floor underlayment. It can achieve compressive strengths up to 4000-4500 psi, and will provide a smooth finish over concrete, precast, wood frame, and old cracked lightweight.

To learn more see Choosing the Right Floor Underlayment

Acousti-Mat Sound Control Systems
Acousti-Mat CLP is the low profile permanent sound control solution for concrete.
Achieving a Delta IIC of 19, it provides approximately 75% reduction in impact noise on concrete floor systems

Acousti-Mat II is a breakthrough in sound control, putting an end to noise complaints even where hard surfaces such as ceramic tile and wood floors are used.  Coupled with a Maxxon underlayment product the Acousti-Mat II sound control system can cut airborne and impact sound transmission in half.

Acousti-Mat 3 provides the ultimate solution for severe sound control challenges.  In open beam or concrete slab construction, new Acousti-Mat 3 gives you the sound ratings you need.

 

Wear Surfaces and Toppings

Maxxon DPM (damp proof membrane) is a unique 2-part epoxy based product which prevents the passage of water vapor and moisture through slabs or walls on or below grade.  It provides a water vapor barrier for the installation of most floor coverings including VCT, sheet vinyl, carpets, wood, laminates, epoxy, terrazo and synthetic.

Wear Top Level-Right Wear Top is a self-leveling portland cement based topping for resurfacing concrete floors. This high strength product is fast to install and will accept foot traffic within two hours. 

Portland Self-Leveling Underlayments

 

Level-Right, Level-Right Plus, and Level-Right FS-10 are portland based self-leveling underlayments that can go on quickly in depths from 0 - 3". They will provide a temporary wear surface in as little as two to four hours after application to keep your project going ahead. 

 To learn more see Choosing the Right Self-Leveling Underlayment.

 
Copyright 2007 Acoustical Floors, Inc.™ Floor Technologies Inc.™